Guadeloupe solar assistant jk bms

This guide is for the original JK BMS. See our JK inverter BMS guideif you have their newer "JK PB" BMS range. . The typical setup requires the two components below. We do not sell any of them. 1. JK BMS RS485 module 2. USB RS485 adapter (ensure it's not TTL). We recommend Ftdi chip adapters. Note you can also use a USB TTL. . On the SolarAssistant configuration page, select the protocol below. Select one or more USB cables and click connect: Plug the RS485 USB cable into the SolarAssistant monitoring. [pdf]

FAQS about Guadeloupe solar assistant jk bms

How do I connect a JK BMS to solarassistant?

Select one or more USB cables and click connect: Plug the RS485 USB cable into the SolarAssistant monitoring device. Once you click "connect" on the configuration page, you should see each BMS show up as a battery pack as shown below. One pack will be shown for each JK BMS connected in step 2 above. How to connect a JK BMS to SolarAssistant.

How accurate is solarassistant BMS?

Let SolarAssistant perform it's own state of charge (SoC) calculation by counting power flowing in and out of the battery. This is a good fallback option for anyone who can't get a real BMS reading. It's less accurate than a Victron BMS but much more accurate than the standard voltage based readings of an inverter.

How do I configure a JK BMS to use 4g-gps?

When using the port on the left, you need to configure the BMS to use the "000 - 4G-GPS" protocol using the official JK BMS software. This is the protocol also used by the original JK BMS. On the SolarAssistant configuration page, select the "JK BMS" protocol as shown below. Select one or more USB cables and click connect:

Does ESP32 work with JK-BMS?

This ESP32 is monitoring the JK-BMS as is in the picture. (I'll mount it later) through bluetooth. Love ESP technology! Would you be able to say how you got the ESP32 working with your JMS into Home Assistant? I'd love to sort that out - have the parts here! Would you be able to say how you got the ESP32 working with your JMS into Home Assistant?

Does esphome support solar assistant?

ESPHome component to monitor and control a Jikong Battery Management System (JK-BMS) via UART-TTL or BLE - syssi/esphome-jk-bms Adding support to Solar Assistant should not be an issue. Click to expand... I would like to sincerely tank you for sharing the functionality freely and not asking money for it.